Anyone had experience with this vendor?

[Whitephrog]

https://www.ebay.com/itm/201215982436?_trksid=p2060778.m1438.l2649&ssPageName=STRK:MEBIDX:IT

 

[Rut]

Ray,
i bought a set early on and the stampings were really shallow, no stiffeners on the bottom, and the fit was a challenge. The vendor offered to refund 1/2 the cost if I would keep them, but they were returned anyway. I think he's a good vendor, but his product was not up to restoration standards.
Rut

 

[mightymidget]

not sure if same vendor, but will only buy from major supplier now, the set I purchased were warped, bent up bad.

 

[Whitephrog]

Is this the same company?

https://www.c2cfabrication.com/store/1958-64-sprite-front-floor-pan-rh/#prettyPhoto

 

[histerical]

https://www.c2cfabrication.com/store/1958-64-sprite-front-floor-pan-rh/#prettyPhoto
fits 1958-1964 and 1948.

 

[sqbsprite]

I like the fact that they are made in USA.

 

[Rut]

Ray,
Thats the same company. Again, the stampings are very shallow and it would not be good for a restoration, but might be OK for rusty metal replacement if you have really good skills. You will need to use the rails from your old pans, drill and install any hardware, captive nuts, etc.
Rut

 

[nomad]

I've got a set of the good ones I will probably never need. I'd part with them for the same money!

Kurt.

 

[Whitephrog]

Kurt

Thanks for solving my dilemma.