Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I seem to be finding conflicting information for the cylinder order on an XK140. Some say cylinder 1 is nearest the radiator and some say it's nearest the firewall. Is there any place I can look at a schematic that not only shows cylinder number but it's coresponding location on the distributor cap? Mac
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
XK140 firing order
- Thread starter Mac
- Start date
Share this page
jessebogan
Jedi Knight
Offline
On all Jaguar XK engines the number one cylinder is nearest the firewall. If you remove the number 1 plug and "bump" the engine over with your finger over the plug hole, you can easily tell when that cylinder has compression. Align the timing marks on the crank damper(or flywheel if so equipped), remove the distributor cap, and where the rotor points is number 1. hope this helps
John S Farrington
Jedi Warrior
Offline
The number one cylinder is the rear most contrary to in front. The position for the number one spark plug lead on the distributor cap is at the eleven o'clock position as you look down on the distributor from the passengers side. The "one way" dog of the distributor to its drive should be set up that way when the engine is assembled. Occassionally this was not done properly during rebuild and allowances have to be made for proper timing. As Jesse said, you have to align the position of the number one spark plug wire with the position of the rotor when the number one piston is at TDC and in compression.
Offline
Hiya Mac, all,
According to the factory manual: "1,5,3,6,2,4" and "No. 1 cylinder being at the rear of the engine unit."
John has seen the same thing I have: On reassembly there have been "liberties taken" with so many of these units, no guarantee you have a properly aligned dizzy "dog". But with the "finger method" or correct dial indicator setup and cam observation you can determine #1 compression stroke and distributor #1 rotor location.
Timing from #1 would be the same as using #6... 180 degrees apart at firing, (SHOULD be) same place/position in rotation of crank.
According to the factory manual: "1,5,3,6,2,4" and "No. 1 cylinder being at the rear of the engine unit."
John has seen the same thing I have: On reassembly there have been "liberties taken" with so many of these units, no guarantee you have a properly aligned dizzy "dog". But with the "finger method" or correct dial indicator setup and cam observation you can determine #1 compression stroke and distributor #1 rotor location.
Timing from #1 would be the same as using #6... 180 degrees apart at firing, (SHOULD be) same place/position in rotation of crank.
