• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A WTB Pulley and Fan for TRactor Dynamo

Share this page

SASSAMON

SASSAMON

Senior Member
Offline
Thank you all. A fan and pulley are on the way to mate up with my DynoAlt.


Hello All

Just posted in the classifieds forum but am also posting here because not everyone checks the classifieds.

Just received my new DynoAlt today.

The DynoAlt does not come with a fan or pulley and I would like to purchase a set.

The part numbers for the TRactor engine dynamo are:

102266 Pulley Dynamo
102986 Fan Assembly

I am in Massachusetts.

Please let me know how much you would like for the parts including shipping.

Also please let me know how you would like payment.

Thank you,

Roger Colson

SASSAMON
 
Last edited:
Roger- you are asking for the std pulley and fan for a TR3 generator? Can supply that. $20 shipped to you.PM your email address for picture and payment info.
Marv
 
SASSAMON said:
...

Just received my new DynoAlt today.

The DynoAlt does not come with a fan or pulley ...
Click to expand...

Measure the diameter of the shaft on the new "DynoAlt that you got. There's a good possibility that the shaft size is different then the original dynamo for the TR. In that case, you'll most likely have to bore them out, as the new shaft is most likely 17mm.


 
martx-5 said:
Measure the diameter of the shaft on the new "DynoAlt that you got. There's a good possibility that the shaft size is different then the original dynamo for the TR. In that case, you'll most likely have to bore them out, as the new shaft is most likely 17mm.
Click to expand...

Thank you Art for the heads up on the shaft size.

The shaft of the DynoAlt in my possession measures 0.620 inches ( 15.61mm ) in diameter.

Roger
 
Back
Top