• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

WTB +.040 piston with con rod for 2639cc Longbridge 100-6

Share this page

6

603000

Freshman Member
Country flag
Offline
needed for engine restoration: qty 1 +.040 piston with connecting rod for 2639 Longbridge AH 100-6 engine.
 
I have a full set of con rods out of a scrap tricarb engine . The rods are fine and I have two sets original standard pistons as well if you decide to sleeve the bores and go back to original size .
 
Healey Nut said:
I have a full set of con rods out of a scrap tricarb engine . The rods are fine and I have two sets original standard pistons as well if you decide to sleeve the bores and go back to original size .
Click to expand...

I would be interested in the 6 connecting rods. Please PM with pricing and contact info. Thank you, Dan
 
steveg said:
Boring a 2600 to 3000 is a bad idea and can lead to catastrophic failure. Mike Salter has documented this I believe on his blog. Just saying...
Click to expand...

Steve,
I am already running +.040 in the 2639 engine for the past 25 years. I am not boring the block out. I just want to use more modern pistons. The choices are non existent for the early Longbridge pinch bolt small end connecting rod. That is why I want a set of later bushing type small end connecting rods from a later engine.

Thanks for the warning about boring open any further. but that is not my intention.
Dan
 
Pm sent
 
Back
Top