• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Worn Hub Extension Studs

Share this page

Rob Glasgow

Rob Glasgow

Jedi Knight
Country flag
Offline
The nuts on the five studs on the driver side hub extension came lose and ruined the studs. Is it possible to remove and replace the studs without removing the bearing hub housing? In other words, is there enough room between the hub carrier and the brake backing plate to drive the old studs out and insert the new ones? There is recent thread about removing the hub carrier so if necessary, I think I can go that route, but was hoping for an easier solution.
 
NO ROB I think you will be required to remove the hub because the new studs wil require pressing in.--Fwiw--Keoke
 
:iagree:

No short cut for this one, Get the big spanner out and the pullers, remember, right hand side , right hand thread, left hand side, left hand thread.

:cheers:

Bob
 
Back
Top