• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Wiring Harnress and Brake Line Routes

Share this page

T

TodE

Jedi Hopeful
Offline
I am finally putting my 1955 BN1 back together! Yah! When I bought the car somebody made a homemade wirimg harness and mounted it with nylon tie wraps. Along with non original gas, and brake lines. Does anybody have good pictures of the routes from the front to the rear of the car?

Thank you,

Tod
 
Nobody have have any pictures? If that's the case, are all models the same routing? From BN1 to BJ8?

Thanks,

Tod
 
TodE said:
Nobody have have any pictures? If that's the case, are all models the same routing? From BN1 to BJ8?

Thanks,

Tod
Click to expand...

NO but the wire harness routing is similar.
 
Hi Tod,

I would suggest you go to john Sims site at www.healey6.com. He has a Technical tab ( https://www.healey6.com/technical.htm ) that includes a section on wiring harnesses. There are a number of entries (some with pictures) which describe the installation of harnesses in a BN1. Additionally, I would suggest you contact Rich Chrysler (a frequent participant on the Healey List) and the other authors with any specific questions.

By the way, there are a number of BN1-directed articles on this site that could be of assistance.

Good luck,
Ray (64BJ8P1)
 
Contact me by direct email and I can send you lots of good BN1 pictures, including routing of all these items.

Rich
 
Back
Top