• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

wiring harness on passenger side

Share this page

msoylemez

msoylemez

Jedi Trainee
Offline
Hi,
Installing the new harness on my bugeye...just wanted to confirm it travelled back to the rear of the car via the passenger side of the car.

Thanks.
 
Just finished rewiring mine. The harness travels down th passenger (RH) side, underneath the interior panels. Back of the door opening it goes into the body and over the rear wheel to the rear. I probably have a few photos from pulling my harness I can post when I get home if it would be helpful.
 
Go Drew! Already "payin' it forward!"

YAY!
 
Drew, that would be great. thanks.

I wonder if there is a way to get the harness *into* the body (rocker panel?) before the "back of the door opening" as you mention. This would allow for a more finished look, don't you think? Perhaps it would be a bad idea from the standpoint that water tends to get into the rocker panels, however...

Mustafa
 
There didn't seem to be a way to put the wire into the rocker any closer to the front, without drilling holes and such. With the panels in place, you really can't tell it's there. Here's a couple shots from when I took out the old wires:

wire1.jpg
wire2.jpg

wire3.jpg


Hope these help.
 
Back
Top