• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Windshield to body seal

Share this page

AndyH

AndyH

Freshman Member
Offline
OK, I'm looking for some clarification here. The Moss catalog windshield installation instructions seem to indicate that the windshield to body seal can be replaced with the side pillars still on. I say the only way to do this is to unbolt one of the pillars and pull it off. If that is true, does this cause any problems down the road? Will the windshield to frame seal be impacted? Are there any other possible problems?
 
It can be done with the side posts on, but I prefer having them off. The windshield glazing will survive assuming it's in good condition and has not been glued in place.
 
If you're going that far, go all the way...you can get it on with some work, lemme say it that way.
 
Back
Top