• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A Windshield frame/doglegs removal

Share this page

mrv8q

mrv8q

Luke Skywalker
Offline
Hey, guys, can I remove the four screws and tap forward and remove the windshield frame and doglegs as one assembly?

if so, looks like I need to pull the wipers and the chrome surrounds around the wipers.

Looking to do a nice wax job.

Thanks in advance.
 
Yes you can remove the windscreen as a complete unit by removing the 4 fasteners holding the assembly the the car.

Beware, on early TR3s the "screws" are actualy 1/4 turn Dzus fasteners. Not sure when they changed to screws, could have been at TS60000.

The wiper arms do need to be removed but no further items. The rubber seal at the bottom of the frame will flex over wiper wheel boxes. Just watch while you are moving the assembly.

Roger
 
Last edited:
mrv8q said:
...looks like I need to pull the wipers and the chrome surrounds around the wipers...
Click to expand...

I just remove the wipers -- then ease the rubber seal up over the bezels as the windscreen comes forward.

I can do it solo as I get lots of practice, but the first time it may be stubborn and you will want an assistant to steady it as you remove and lift away.
 
Excellent, thanks!
 
I found the removal of the screws on my post 60k car to be troublesome. You need a screwdriver that fits the screw slot, a bigger than ordinary size and a little penetrating oil on the inside. The inside nuts are welded to a plate that is spot welded to the scuttle and remain there. One of the screwdriver tips for my impact did the trick. (I used the tip only with a ratchet rather than the impact so I had better control.)
Tom
 
Plus, if you have a TR3A, like in your trailer, then remove the screws and just lift upward. Only the early style windscreens need to slide forward.
 
CJD said:
...Only the early style windscreens need to slide forward.
Click to expand...

'Early' in this context includes many TR3As. Mine (TS47905) has Dzus fasteners and slides on.

I think the bolt-on stanchions came in with the new body tooling introduced at TS60000.
 
Yep, CJD is right. Removed the 4 screws, (I had been been here 10 years ago replacing the lower rubber seal) and tapped a few time with a mallet. Everything loosened up and I was able to awkwardly place the windshield frame assembly on the tonneau cover.

Surprised me too... tapping forward but eventually just pulled upwards... 5 minute job.

Thanks to all.
 
Yep, screws not Dzus. Happily, another 5 minute job with the wife’s help reattaching the frame. While I was there I quick tap and die job on the screws and body mounts, so I can do this again in 10 years.

TS58370 is close to the “magic” 60k change point. After all this time I don’t know if there is a TS59999 car. I’m guessing there is a jump from the mid 59XXXs to the 60k cars.

Thanks all for the help!
 
Back
Top