Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
What is the correct routing for the washer tubing from the Tudor bottle through the BJ8 firewall? The tubing currently goes through the big grommet with the wiring bundle by the valve cover. Is that correct?
I see a small hole below the voltage regulator and another up high just below the lip of the shroud. What are they for? Regular tubing is a shade to big to fit through the small holes. Was there a special tubing?
The washer won't squirt if left sitting for awhile. The pump is new. The one way valve seems ok. I suspect the pump is loosing it prime. Maybe clear tubing doesn't make a tight enough seal. Anyone else have similar problems?
I see a small hole below the voltage regulator and another up high just below the lip of the shroud. What are they for? Regular tubing is a shade to big to fit through the small holes. Was there a special tubing?
The washer won't squirt if left sitting for awhile. The pump is new. The one way valve seems ok. I suspect the pump is loosing it prime. Maybe clear tubing doesn't make a tight enough seal. Anyone else have similar problems?
