• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR4/4A windscreen frame bottom rubber seal......help please.

Share this page

M

malbaby

Jedi Warrior
Offline
About to install the windscreen frame with a new rubber seal.
Trying to decide wether to trim it flush with the frame now or wait until after it is fitted and tightened down.
Comments welcome..
 

Attachments

  • DSCF2899.jpg
    DSCF2899.jpg
    59.2 KB · Views: 162
I was faced with the same issue when I redid my TR250 and....I can't for the life of me remember what I did, I think I trimmed it before, I would worry about scratching the paint and access if I waited until it is one the car.
 
Trim it some now and install but leave a little long, if you don't like it after installation you can put a thin piece of metal underneath and re trim with razor blade

marv
 
I trimmed mine while off of the car and they look very good. If you want to wait I suggest using a very sharp pointed X-acto knife. Lots of control and a very small blade.
Charley
 
Back
Top