• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

What to use for spacer on rear springs?

Share this page

RickB

RickB

Yoda
Offline
I've got the nose of my Midget down in the weeds now, so what do I use for spacers in back?

I'm going to try just keeping the U bolts and put in a 1 inch spacer, also remove the rubber thing at the front end of each spring for an extra 1/2 inch. (I heard about that somewhere...)

Hopefully that will give me 1.5 inches lowering of the back.

BTW I seem to have gone overboard a bit with the front lowering. The wheels turn fine without me in the car, but when you add the nut behind the wheel (me) a little tire rubbing happens on sharp turns.
 
LOL, any job worth doing is worth doing two or three times. Ask how I know this.
 
heh. If ya ain't done it three times, ya ain't done it right yet. /bcforum/images/%%GRAEMLIN_URL%%/jester.gif
 
Well I think I'm getting good at replacing front coil springs.
The last one only took me half an hour.
Removing one spacer nut from each bolt should only take 10 - 15 minutes, especially since I used bolts that are about 1 inch longer than I needed. Just loosen all the bolts, take off one nut at a time and then tighten them all back up.
With the air compressor it will be a cinch.

Actually getting all the tools out & jacking up the car and putting everything away again will be the hardest part. /bcforum/images/%%GRAEMLIN_URL%%/wink.gif

Oh yeah - what do I use for spacers on the back?
 
I'd probably just buy the ready made ones since they already have provisions for the locating pin.
 
Trevor, Do you have a source for the ready made spacers? I have heard that some have moved a few "slats" from the top to the bottom of the actual rear springs itself. ------ Or the other way around.
 
Winners Circle
(216) 889-4666
They'll have the 1/2 elliptical blocks and the 1/4 elliptical wedges.
 
Back
Top