• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A What size and threads for corner finisher on TR3A windshield

Share this page

T

TuffTR250

Jedi Warrior
Country flag
Offline
Can someone tell me the size ( diameter and length) and thread count per inch on the tiny screws for the corner finisher (Moss p/n 802-665). The corner finisher holds the bottom rubber seal in place at the bottom of the stanchions. Also, what material are the finishers made out of? Thanks!
Regards,
Bob
 
I think the screws have a sheemetal thread to them, and they are about 1/4" long slotted head. Remember the frame is bronze or brass so it's softer than the screw. Not sure what the material is for the finisher. I had mine re-chromed.
 
Last edited:
TuffTR250 said:
Can someone tell me the size ( diameter and length) and thread count per inch on the tiny screws for the corner finisher (Moss p/n 802-665). The corner finisher holds the bottom rubber seal in place at the bottom of the stanchions. Also, what material are the finishers made out of? Thanks!
Regards,
Bob
Click to expand...

I also think they are sheet metal screws. You can see their heads in post #2 of this thread.
https://www.britishcarforum.com/bcf...Step-by-Step&highlight=tr3+windshield+rebuild
 
Back
Top