• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR6 What goes here? [TR6 pictures attached]

Share this page

T

tdskip

Yoda
Offline
Still debating about painting here, but in any case I need to get the interior sorted at some point.

Can anyone identify what these holes on the rear deck are for?

I put white arrows where the holes are - and they are symmetrical from side to side.

Thanks!

74TR6interiormysteryholes002.jpg
 
If they are on both sides, somebody had a roll bar installed at one time.
 
If you are going to paint, that sheet of tar should be peeled off, can be done with a sharp, wide chisel, a mallet and elbow grease.
 
TR6BILL said:
If they are on both sides, somebody had a roll bar installed at one time.
Click to expand...

Oh - duh. Seems kind of obvious now that you state it Bill.

I'm not planning on installing one so I think I'll just weld up those holes and be done with it.

And yes, all that crap will come off before anything gets painted.

Thanks!
 
Tom, FWIW, here's a pic of my unmolested one:
IMG_0886x.jpg
 
tdskip said:
Is yours Maple or Sienna brown?
Click to expand...

Whichever is uglier.... one day I hope to buff it out; right now it's a faded baby-poo brown ...
 
Always fun to weld right beside the gas tank. What precautions do you plan to take?
 
DougF said:
Always fun to weld right beside the gas tank. What precautions do you plan to take?
Click to expand...

I was going to put the cigar out first - lol.

Actually I was planning on putting the metal/foil back heat shield material up as a temporary barrier first. Stray sparks here don't seem like a good idea - thanks for asking Doug.

Kodajna - yes, the leading threoy was that there was a roll bar there at some point.
 
You might want to seal the throat of the tank since the gas cap seal is good against liquid, but not necessarily fumes. Once sealed, you may even be able to relight that cigar. :laugh: ...not!
 
TD get a roll bar or use rubber plugs to fill those holes (that's what Triumph did), a whole lot less expensive.
 
Back
Top