• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Weekend discovery

Share this page

Rut

Rut

Obi Wan
Country flag
Offline
This technique is probably old news to most of you, but I pulled out my vibratory polisher that I use for brass cleaning and replaced the media with one suitable for small steel and aluminum parts. I can't believe how good this thing works to remove light rust and polish parts! I clean the dirt and grease before putting them in the media and they look like new 12 to 18 hours later. I've tried to stay away from the wire wheel to keep from removing the zinc coating and this does the best job of anything I've tried.
Rut
 
Bill,
It's just a Hornady brand unit that I use when I reload. I think I paid about $55 new a few years ago from a local store. I normally use corn cob media with a brass polish and for this application I'm using walnut shells with a red rouge media. It cuts pretty slowly, but I had a couple of gallons on hand.
Rut
 
Walnut shells are great for that, didn't think to put my car parts in tho - good tip!!
 
Back
Top