• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Wedge Wedge help needed

Share this page

PATR8

PATR8

Jedi Knight
Offline
Ok, I have the engine rebuilt, on the car, bolted in.... But I cant get the trans xross member to mount. One side, either side, will match but the other side is two inches to the rear,,, what did I screw up? I rea ly want to be diving it tomorrow and this is the only thing realy that might stop me.

Worst part is I have this trouble every time
 
Do you have it going in the right direction? It should be with the curve of the bracket pointing rearward.
 
You probably have the engine part of the motor mounts on the back side of the subframe mounts. They need to be on the front side of the subframe mounts unless you want to redrill the trans mounting holes in the body.
 
Todd hit it on the head, I had the mounts behind the subframe... I am not sure how I did that, Thanks Todd. This is why I love this forum, so many smart people in one place
 
David, I mounted mine like that . Though I had a reason and I had to redrill the holes
 
The tab for the motor mounts goes behind the subframe tabs......why would you put them infront moving the engine forward in the car? There is only about a 1/4" difference between behind or infront of the subframe tab. Factory was behind the subframe tab.
 
Actually it's a half . I thought so to but was proved wrong. I moved mine as I could not get my fresh air intake on with out beating the heck out of it.
 
Back
Top