-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
-
When posting a classified ad, you MUST select a prefix from the drop-down next to the subject line. If you don't you will get an error and your ad will not be posted!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Webber DGAV3D
- Thread starter Blueghost
- Start date
Share this page
Thanks to all for your suggestions. Yes, fuel stavation, & I still can't believe what I learned. Re-installed old electric pump because I could measure psi and flow. 5 cups per minute, and develops 5.5 psi, all good. Then hooked up to carb cover over a container to measure flow thru needle and seat. I can spit faster; a teaspoon in 15 seconds. I had already verified internal screen filter was clean. OK why? The carb cover assembly has 2 identical looking, 3/8" diameter, brass hose barb inlet tubes. They point oposite directions. One tube is clearly a standard inlet. I assumed the other hose fitting, which was capped by PO, was also another inlet fitting, specifically there when the carb is used in multiple carb installations. (I worked on dual holleys and tri-power carbs in the 60's) For those who have followed this saga since the 1st post, recall that I mentioned I failed DEQ & had gone thru the carb just as a general clean up, & installed new carb kit w/ needle and seat. What I didn't say is that, to clean up fuel line routing, I installed fuel inlet hose to the other side inlet fitting. Turns out this 3/8" line fitting is not an inlet tube; the internal end of the tube is actually sealed, except for a .018" bleed hole drilled thru to the internal filter housing. I can only assume this fitting is meant to be hook-up for a fuel pressure gague wet line. As a restrictor orifice it would reduce a dangerous fuel leak should the gague or line fail. Bottom line. All fuel was going thru .018" orifice, to needle and seat, & into bowl. I have omitted several interim steps checks taken to solve problem. 50 MPH and less it will run. Hi rpm/speed, will starve. I would have bet it wouldn't even run w/ that much restriction. Haynes Webber Carb manual #393 (excellent) does not cover this fitting. Webber gurus take note.