• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Wanted: 2 Fast-idle adjusting screws for HS carb

Share this page

M

MGNoir

Jedi Hopeful
Country flag
Offline
OK so a while back I did a full strip, clean & reassemble of my carbs - and in the the process lost the two fast-idle adjusting screws, so no choke.

I went down to the local hardware store and spent a while trying to find a matching thread but no luck - it looked like it would be pretty close to a 6-40, if they had such a thing.

Can anyone suggest where I can get a set of these screws, or happen to have a pair they'd be willing to part with?
 
If no one has some used ones lying around and if they are 6-40, try McMaster-Carr. They have just about every fastener made. You may have to buy more than you need, but they are cheap. The web address is: https://www.mcmaster.com. The only ones I saw were a socket head cap screw instead of a slotted head. You just need to know the exact size before ordering.
 
That's sort of the catch, knowing the right size. I found a 5-40 that seemed to match the thread count, but the diameter was too small. 6-32 fit the hole and would thread in a bit, but then bound up since the thread count was off.

Ends up that the top throttle adjusting screws are the same as the bottom (missing) fast-idle adjusting screws so I have that as a reference.
 
Try Home Depot and all the other Hardwares as well.
 
I've got some old carbs laying around. If you can't find any let me know and I'll drop a couple in the mail to you.
 
Thanks Jim. If Home Depot doesn't come through (the main place I went to had a big selection including some pretty obscure stuff) I may take you up on that offer!
 
Back
Top