• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Valve adjustment question

Share this page

H

hottvr

Jedi Warrior
Offline
Which feeler gauge should be used for valve adjustment on a 76 B? Dumb Haynes manuel doesn't say.
Rick
 
Valve gap is 0.015 in (0.38 mm) cold for both intake and exhaust valves.
Dave
 
See page 24 in Haynes: Hot .013, cold .015, both valves. Or you can get it from the Moss catalog, page 3 in parts list section:
.013 warm, both valves.

Personally I like .013 for my 78 which is the same as the 76. Some people prefer a bit of noise so they know their engine is running.

Guinn
 
I, like Guinn, like my valve lash set at .013 cold. I've never had a problem with that setting and the valve train is a little quieter. It might sound a little ridicules, but I check my valves twice. After the initial setting, I run the engine for about a minute and then go over them again. PJ
 
Hardly ridiculous, Paul! Call it 'prudent' or 'professional'! /bcforum/images/%%GRAEMLIN_URL%%/grin.gif
 
Hardly ridiculous, Paul! Call it 'prudent' or 'professional'! /bcforum/images/%%GRAEMLIN_URL%%/grin.gif

...and a "snug" 0.014" is good for an 18V street engine (warm) around here. I'll use a "Go, no-go" on pass #2: 0.014" fits, 0.015" doesn't. But that's just me.
 
I do the same, Doc. Check twice except I use .013:go, then .014:nogo. Except for that darn #2 valve on my particular engine which I set by ear as the rocker is grooved.

Guinn
 
Where does the go-no go feeler gauge come from?? I got one at napa but it is difficult to use. The blades are 1/2' wide-but have two measurements per. One edge of the blade is one measurement while the other edge is a different measurement.

Paul
 
Setting the rockers by ear. Remember way back in the dark ages when the old chevy cast iron sixes were around? The MG engines remind me of those old chevys. We used to set the rockers with the engine running, by feel. You could actually feel the difference in the rockers by holding the tip of the rocker between your thumb and finger and if they didn't make noise, they were set to tight. Ahh, the so called good old days. PJ
 
paul74 said:
Where does the go-no go feeler gauge come from?? I got one at napa but it is difficult to use. The blades are 1/2' wide-but have two measurements per. One edge of the blade is one measurement while the other edge is a different measurement.

Paul
Click to expand...

Two different wires are employed here. One fits, other doesn't.
 
Actually, the Morris B series engine is a pretty direct copy of the Chevy stovebolt 6, except for 2 missing cylinders, so your analogy is a good one!
 
Back
Top