• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Uni-Syn Flow Meter

Share this page

R

RickTM

Freshman Member
Offline
I am looking to save some $ and buy a Uni-Syn off Ebay for carb balancing. Are there different models/sizes of this tool? Which one works for MG SU carbs? Want to make sure I buy one that will work for the A.
 
This is a case of the older the better. I bought one a few years ago and it was a piece of c**p. I suspect there is only one manufacturer and they must be living on their reputation (or I got the only bad one). The tolerances were awful, for all practical purposes it was useless. On a small engine like an MG which doesn't draw much air at idle it was impossible to get the carbs anywhere near close as you couldn't set the unisyn tight enough to raise the air float. Bob
 
Back
Top