• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Turn signal gremlins on BN2

Share this page

bighealeysource

bighealeysource

Luke Skywalker
Country flag
Offline
Well, never fails, go to a judged concours and the turn signals work fine driving up and then once there, one stops working ! So right now, I have cleaned up all the connections coming from the trafficator out through the steering column and thought I had it fixed. But, no, still have issues. It's on the right side. Left works great. Of course on left get running lights okay, but flip over the turn signal tab and front running light stays off and rear light will stay on solid, not flashing. Go figure. At least I know bulbs are good and getting power okay. Now I have to admit I do not recall if the bulbs are dual filament or not so if they are perhaps one filament is out but before I take the glass lens off- which is a pain in the rear - thought I would mention it here. Should I be trouble shooting the infamous flasher relay on the left side of engine compartment ? Any suggestions before I start looking at the relay which means taking off the cold air box duct since I have a 100M ?
Thanks,
Mike:grief:
 
bighealeysource said:
Well, never fails, go to a judged concours and the turn signals work fine driving up and then once there, one stops working ! So right now, I have cleaned up all the connections coming from the trafficator out through the steering column and thought I had it fixed. But, no, still have issues. It's on the right side. Left works great. Of course on left get running lights okay, but flip over the turn signal tab and front running light stays off and rear light will stay on solid, not flashing. Go figure. At least I know bulbs are good and getting power okay. Now I have to admit I do not recall if the bulbs are dual filament or not so if they are perhaps one filament is out but before I take the glass lens off- which is a pain in the rear - thought I would mention it here. Should I be trouble shooting the infamous flasher relay on the left side of engine compartment ? Any suggestions before I start looking at the relay which means taking off the cold air box duct since I have a 100M ?
Thanks,
Mike:grief:
Click to expand...


Mike,

It sounds like it's your 3 pin flasher unit. Give me a call and I can help you troubleshoot! (I sent you an email with my number.)

Duane
 
Back
Top