carpecursusII
Jedi Trainee
Offline
OK, recently I refreshed the front suspension on my new to me 250. I installed the trunnions by screwing them all the way up then backing off until they were positioned correctly, this was about a 1/4 rotation back down. I looked under the car and noticed the seal had split, did I screw the trunnions on to far, should I back them off a full rotation?
Secondly, I did not know about the change from grease to 90wt oil, I used grease. Are there any opinions on using grease vs oil?
Secondly, I did not know about the change from grease to 90wt oil, I used grease. Are there any opinions on using grease vs oil?