• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Transmission will not shift into any gear

Share this page

G

Gunner

Senior Member
Offline
I finally drove my 67 Midget around the block... everything worked great.. first gear a little noisy, but seems normal. Engine absolutely purrrrs. After I backed her into the garage, shifting out of reverse, transmission then stuck in the center and will not go into any gear. I can kinda mess with it some and seems to want to go back into reverse, but I don't want to damage anything . Where should I start to troubleshoot? /ubbthreads/images/graemlins/driving.gif
 
Sid

The reverse lock out plunger may have gotten stuck.
I have seen this twice. Take off the shifter metal housing.
You can see the plunger on the right side top of the tranny shift tower. a shot of oil should fix it. You might have to push it down with an awl if it is stuck, wiggle the shifter towards reverse, and spray some oil on it.

Is the shifter bolted tight to the gearbox? 3 bolts that you can see once the shifter metal boot is removed too.
Those are the easiest checks anyway. Hopefully the tranny did not self destruct.

Frank
 
Frank

I see a spring on the right side under the shifter. Above the spring is a bolt through the shifter housing. Any thing else in there I can manipulate to get the thing out of reverse? The shifter was bolted tight to the shift tower. I'm trying not to be too forceful with the shift lever because it shifted easily before this incident.

Thanks

Sid
 
Back
Top