• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Transmission Problems

Share this page

B

bugman

Freshman Member
Offline
Please Help!
Just finished transmission rebuild. Replaced first gear, reverse gear and lay gear in 1960 Bugeye. Now it pops out of reverse and there is a loud whine when in first and reverse.
Don't have a clue what is wrong. Had help from an experienced mechanic. Thanks in advance for any help or advise.
 
yep first will whine, never tried to go fast enough in reverse to get a whine.
 
The whine is very typical of the tight gear interface for these "straight-cut" gears. 1st, Rev. and the laygear for both are straight cut. Only the input drop to the laygear, 2nd and 3rd are helical gears and hence a good bit quieter. Poping out sounds like a detent issue on reverse. Reverse's detent is on the bottom of the gearbox in the front hole under the 9/16" headed short bolt. Make sure you have a proper fill on the gearbox, using a good quality 20w50 and turn the CD or radio up a notch or two.

BTW, If you are in the Robin Rd. area across from the church off NC150, look up my buddy. He is a cerified LBC nut. 2- Spridget Squarebody HP SCCA racers, 1- 1973 Squarebody street, 1-Bugeye Vintage Racer, 1-Bugeye street and a basement full of 40+ years of LBC addiction. Lotus Elan and street Bugeye in his youthful past as well. Just look for all the street cars and trailer in the drive. Both he and his girlfriend are life long SCCA types.

Take care,
Mike Miller
 
Back
Top