Well, as they say when it rains it poors! Things went from bad to WORSE. While trying to diagnose the problem, they took the circuit breaker out of the loop and used a jumper in its place. Once they did that, the lights started to work at the correct speed. They did this several times and it was all working. Then on say the 12th test of the lights going up and down, all heck broke loose, wires starting smoking and melting!!!!!!! So now they are going to have to re run several wires. The conclusion from all the mess was that a ground wire and a live wire must be touching some where, and the reason the lights were going up so slowly was that the breaker was getting too hot and shutting off, and as it cooled of a little bit, it would then raise them a little at a time! So the question now is, where are they touching? Any suggestions? Thanks to all this nightmare, I am now going to miss the Car Show this weekend in which I was entered, to say the least I am extremly disappointed, but still trying to stay positive that it can be all figured out. So any help is greatly appreciated! Also, when they were going up and down propperly for the short period of time, the right side would " wink" go up go down, and then up again and stay up. A seperate issue?! No one is sure. Also, the high beams were not working at the time either. The fuses were not getting any power.
Rod
rsm@loumarks.com