• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Wedge TR8 Header Install

Share this page

I'm sure you can visualize it. It's an upright machine about 6 feet tall with a table and a drill mounted above it. Great for putting holes in things like wood, metal and header gasket material. Use the press to drill the holes for the bolts and at the four corners of the exhaust port cut out. Works better if you stack several together at a time.
 
Been a little side tracked with things here and need to get to the wrench turning part of this header change.

Anyway, should the mounting side of the headers look like this? The raised area around the port concerns me.

RST47137.jpg


RST47141.jpg
 
No, I had to have mine ground flat.
You would think that was taken care of by now.
I thought enough people have said something about it.
Take it to your favorite machine shop.
 
That's how mine looked, Randy, and I had the same concern. But when I thought about it, I realized the flange plate would have to be spot on to get a proper seal. This way there's less metal to have to mate to the head. Installed them with no issues.
 
Don: That's how I felt.

Mickey: I understand that concept, but I do not think it is proper. I am pretty sure it will work, but it might look a little "chop shopped".

Considering these came fully powder coated, they are either going in the car or going back.

Anyone have close up pictures of The Wedge Shop's headers actually installed?
 
I'll see if I can find pictures from mine - the one Brosky has now. If not, maybe he can shoot one to you.
 
Best I can do - can't really tell much from here:

TR8Engine004.jpg
 
One more:

TR810-8-06004.jpg
 
Wouldn't be flush with the head. "member, gasket there.
 
Randy, just sent the only pic I think would help to
"tessfamily.com
 
I would say not much different.
It's not the look it's the chance of leaking eventually.
Hopefully the East Coast boys will chime it too.

I don't even think you could see that there was a difference by sight
 
That raised lip is the sealing area of the header against the head. It is suppose to be there. The thinking is greater pressure per square inch of sealing area will lead to a better seal. Remember, the header gasket is under tremendous heat and pressure. The smaller sealing area allows for thermal expansion, and concentrates the clamping force. Remove the raised area only if you like replacing gaskets often. They install easier if you cut the flange so that there is two flanges serving 2 ports apiece instead of one long flange.
 
Back
Top