• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR6 TR6 Hayden Pusher Fan Wiring

Share this page

OP
J

JP72TR6

Freshman Member
Country flag
Offline
How do I wire up the Hayden fan in pusher mode - specifically the yellow wire that is for the "key on" connection? Can this wire go to a position on the fuse box? If so, where and how (any pictures)? I'm not looking to do a manual switch, just basic installation.
 
Sort by date Sort by votes
"Key On" would be the White wire side of the fuse that protects the green wire circuits....
That means any time you have the ignition key in the ON/RUN position the yellow wire is going to get 12 volts...is that what you want ?
 
Upvote 0 Downvote
poolboy said:
"Key On" would be the White wire side of the fuse that protects the green wire circuits....
That means any time you have the ignition key in the ON/RUN position the yellow wire is going to get 12 volts...is that what you want ?
Click to expand...
Sounds right, I'll give it a try.
The instructions for the fan say, "Yellow Wire: connect the yellow wire to any key activated circuit. The yellow wire must be connected to a full and constant 12 volt source. Low and fluctuating voltage will cause early relay failure. Red Wire: connect the red wire to the positive wire of the battery."
 
Upvote 0 Downvote
Back
Top