• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR6 TR6, 71 model flywheel bolts, ARP

Share this page

hondo402000

hondo402000

Darth Vader
Offline
I dont have my book in front of me but whats the flywheel to crankshaft bolt size, I want to purchase ARP bolts for these too if someone knows and I dont have to research it

Hondo
 
Hondo,

My machine shop supplied them (ARP) and he had to drill out the flywheel a tiny bit to get the shoulder to fit. I think that Bob said they were the same as small block Chevy.
 
Hey Paul I talked to Bob today and I sent him a list of all the parts purchased so far, and he seemed excited about my project, I asked about adding min of 6 bolts to the flywheel to crankshaft connection and no problem, I also read about the bolts being the same as the chevy bolts, I believe 7/16 by 1 and UNF thread and I am guessing by F , fine and 20 threads per inch, but I am comming to the end of the parts purchase, probably pull my engine in Nov and ship it off to Bob and again I might just make a trip up to RI for the dyno and bring it back on my trailer

Hondo
 
Back
Top