• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR4/4A tr4a rubber trunk seal

Share this page

I believe it would be high side inwards.

As I recall, some replacements vary a bit from original.

What I have (and I think very close to original):

Seal-2.jpg


What someone else got:

Seal-1.jpg


I did have a hard time getting the seal along the lower lip to stay put -- wanted to roll off because of the way the boot lid closes against it. Finally used Gorilla Glue and that has held (hopefully I'll never have to remove it).
 
JerryVV said:
TRF actually suggests using the TR6 seal which I did and it seems to work very well.
Click to expand...

Really? I got one (TR4 seal) from VB, it was too thick and the trunk lid sits proud, so I got the one from TRF, they said it wouldn't cause the problem, but no difference, is the TR6 seal thinner?
 
glemon said:
...I got one (TR4 seal) from VB, it was too thick and the trunk lid sits proud, so I got the one from TRF, they said it wouldn't cause the problem, but no difference...
Click to expand...

Were those seals like the second pic (which to me looks like it is a bit higher)?
 
Back
Top