• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3b lower door seal question

Share this page

B

bob67bgt

Jedi Knight
Offline
Which way does it go? Anyone have a pic of the end (installed) so I can see which way the silly thing goes? Thanks Bob
 
I don't have any pictures for you , but most of the lower door seals that have been reproduced lately have been too fat to work properly. They make it very difficult to close the door when installed. I, among many others on this board have opted to just leave them off.

So, carefully check the size compared to the original, if they are significantly fatter, consider not using them.
 
I do have some old stock seals. They are much smaller than the ones I used at the cowl to door area. It looks like there is room for them. Just not sure which way they install. Not sure about the seals that look like they go up the rear edge of the door also. FUN FUN FUN . Bob
 
This has been addressed before.

Frank Angelfj had an excellent suggestion: Click here to see the full discussion. I recently bought the same rubber so it's still available.
 
Back
Top