• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3A clutch/brake cylinder rebuild

Share this page

C

chuck leipham

Freshman Member
Country flag
Offline
I'm rebuilding the clutch and brake master cylinders on my original owner 1960 TR3A. I've found that all of the all of the TR3 parts suppliers rebuild kits only come with 2 rubber shaft plunger seals. My original internal shafts and book drawings show three seals. Does anyone know if it's been determined that the middle (smaller rubber plunger seal) is no longer needed?
 
Chuck, you posted your question in our forum help forum - which is a place to ask questions about how to navigate this forum. Since you have a specific question about your TR3 I'm moving your post to the Triumph forum. If you're reading this, you are now in the Triumph forum.
 
Yes, that was a change. The kit should have come with the instructions for which seal was eliminated. I thought it was the end one, which was only needed if the other seal already failed...so it was redundant.
 
Don't lose those wavy washers. They are apparently made of unobtainium. And make sure you put them back the correct way around.
 
Back
Top