• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3 turn signal replacement

Share this page

M

Murray

Member
Offline
Has anyone figured out a different way to mount turn signals on a TR3a? I just finished installing a rack and pinion and had to fabricate a method of running the turn signal and horn wires through the steering column. The problem is that the steering column is only hollow for half its length, then there is a u-joint that is the beginning of the rack and pinon installation. Right now the wires exit the u-joint and very loosely wrap around the solid bottom half of the steering column and then onto the wiring harness. This is ok for now but not a good solution.

Is there a lever or switch that can mount on the panel?

Thanks,
Murray
 
Well, you could use an early Sprite switch. They were panel mounts.
#4 in this picture.
Jeff
 

Attachments

  • 8426.gif
    8426.gif
    18 KB · Views: 101
Hey Murray; I used an spring cord from a microphone and drilled a hole behind hub and used the the horn that way. The signals I added a three way switch to the dash.
 
Back
Top