• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3 Furflex - Fuzzy Door Seals

Share this page

martx-5

martx-5

Yoda
Country flag
Offline
I'm putting in the fuzzy door seals on my TR3, and I need to know how and where they terminate. Anybody have pics of both the front and rear of the door when it's opened so I can see how far up they go and how the exposed ends are handled??
 
No photos in hand, but the ends are handled like this:

You're supposed to cut the inner rubber hose to length and leave the fuzzy outer part a little longer (+ or - 1"), then push the fuzzy part into the center of the hose.
 
Thanks. That's what I needed to know.
 
Twosheds said:
You're supposed to cut the inner rubber hose to length and leave the fuzzy outer part a little longer (+ or - 1"), then push the fuzzy part into the center of the hose.
Click to expand...

I agree about the fuzzy part, but on my 3, it wasn't pushed in to the hose, but folded at a 90 degree angle, and tucked under the vinyl-covered panel. I'm talking about the door handle side, of course... Sorry, I don't have a picture. I'd also leave a touch more than an inch. I also seem to remember tacking in the furflex on the door/panel side. This is on a pre-60K car. Hope that's not too confusing!
 
Back
Top