Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Hi folks -- Quick question -- I removed my TR3 hubs and rotors, and have removed the four bolts connecting the two together, but they still seem very attached to each other. Yes they are rusty, and I have soaked them both in PB Blaster. Is there anything else holding the rotor and hub together beyond the 4 bolts and healthy layer of surface rust? Thanks for your help!
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR2/3/3A TR3 Front Rotors/Hubs
- Thread starter Mkutz
- Start date
Share this page
martx-5
Yoda
Offline
I just took mine off last week. That's the rust holding them together after you take out the bolts in the back. It took mine a little persuasion with a brass hammer. The PB blaster should loosen up the rust, but it's a close fit, so you'll have to knock it around with the hammer a bit to get it off. /ubbthreads/images/graemlins/cheers.gif