I have a 1962 TR3B and I’m having problems bleeding the slave cylinder. This is the third time I have bled it it and I don’t remember any problems with bleeding it before. I’ve read most of the threads so I realize this is a much discussed issue. I keep getting air in the system and I’m thinking it may be coming in at the bleed screw. Some have mentioned switching to an EZ bleed screw and I want to try it. The bleed screw is 3/8-24x1 1/4”. The EZ or quick bleed screws I found on-line are either 1 3/16” or 1.283” in length. Lots of regular bleed screws are 1 1/4” but I haven’t found a quick bleed screw of that length. Is it better to go slightly shorter or slightly longer? I can imagine problems with each so all comments are appreciated.
Gary
Gary