• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR5/TR250 TR250 RR Brake cylinder ??

Share this page

R

roofinwilly

Senior Member
Offline
I'm usually on the spridget channel but this question is for an old friend. Hard to believe, but does the original right rear brake cylinder/ hydraulic line fitting have left hand threads? If so, where can you purchase the correct cyl? or correct fitting? Apparently Moss only offers one type of cyl.
 
I've never come across a left handed fitting on a TR. If it feels like it's tightening up, the fitting has probably been over-torqued. There is a shoulder on the nut, between the threads and where the flare is seated. If the nut has been over tightened (this could have happened at the factory) the shoulder mushrooms and after a half a turn out it starts to dig into the threads on the cylinder.
I would just cut the old line and replace the short line to the hose along with the new cylinder.
 
Back
Top