TR5/TR250 TR250 Need Help identifying wires (2 - black) feeding starting solenoid

[angelfj1]

Hi guys! I would appreciate help in identifying two black wires in the bundle that feeds the starting solenoid of my 250. I realize that it is likely that these wires, being black, terminate at some earth ground point. However, I can't identify any obvious place where they were terminated. I don't see an electrical terminal with the broken ends of the black wires. Check out the attached photos where I have identified the other wires in this particular branch of the wiring harness.
Many thanks, Frank

 

[Deleted member 12064]

This may help, prepared by a 6-Pack member.

Ground locations

 

[Deleted member 12064]

I knew I had a picture, just needed to find it.

 

[angelfj1]

Ralph, I can't thank you enough. This is what I needed and not shown in any other manual or article that I have seen in the past. I don't know much about 6-Pack. Is this an organization like VTR or TRA with membership requirements, etc?

Again, a massive thank you!

Frank

 

[angelfj1]

I knew I had a picture, just needed to find it.


View attachment 93468

 

[angelfj1]

YES!!!!! That's it. THANKS!

 

[Deleted member 12064]

Ralph, I can't thank you enough. This is what I needed and not shown in any other manual or article that I have seen in the past. I don't know much about 6-Pack. Is this an organization like VTR or TRA with membership requirements, etc?

Again, a massive thank you!

Frank

It is a organization for 6 cylinder Triumphs, they have an annual group evet called 'TRials'; some links

Log into Facebook

Log into Facebook to start sharing and connecting with your friends, family, and people you know.

www.facebook.com

6-Pack Car Club – 6-Pack Car Club of the Americas

6-pack.org

https://forums.6-pack.org/forum

Log into Facebook

Log into Facebook to start sharing and connecting with your friends, family, and people you know.

www.facebook.com