• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR5/TR250 TR250 clutch fork "pins"

Share this page

heliguy

heliguy

Jedi Hopeful
Offline
TR250 clutch fork "pins"

Has anyone changed the clutch fork pins? Not the tapered pin on the shaft, the 2 pins on the fork that mate up with the release bearing carrier? Do they just press out? Mine are pretty flat on the one side and i would like to change them......
 
Re: TR250 clutch fork "pins"

Those pins are available separately. Another "trick" is to rotate the pins 90 degrees so the new round surfaces engage the groove in the throw-out bearing guide.

If you plan to change the pins, they can be drilled out. The new pins need to be inserted and then hammered from the back to flare out the head - something like an external rivet head. As for MIG welding the pins to secure them, it might be difficult to weld the new steel pins to the cast iron yoke.
 
Re: TR250 clutch fork "pins"

Thanks Don. I allready bought new pins so may as well change them out, but i see what you mean by rotating them to a new "unworn" area.
 
Back
Top