-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR5/TR250 TR250 Bonnet same as TR4?
- Thread starter mwagon
- Start date
Share this page
TR4nut
Yoda
Offline
Not identical. On the TR4, the support or strengthening bar on the backside of the bonnet runs parallel, but on the 250 it is diagonal. Also, on the 250 you will have two cupped receivers for the pointed rubber bumpers. On the TR4, there are no receivers and the rubber bumpers are flat.
martx-5
Yoda
Offline
HerronScott
Darth Vader
Offline
Is it a TR4 or TR4A hood? The TR4A used the same pointed bumpers and cupped receivers like the TR250 that Randy is referring to so it's probably closer.
Scott
Scott
HerronScott
Darth Vader
Offline
I just confirmed that that TR4A brace also runs at a diagonal so I think that other then the holes for the letters/emblem that they are probably the same.
Scott
Scott