• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR4/4A Top Gear Shift Mechanism

Share this page

KVH

KVH

Obi Wan
Country flag
Offline
Moss Motors leaves the following notation after describing the process of replacing the anti-rattle plunger in the gear shift lever:

" Be sure to clean and repack grease in selectors."

I have no recollection of grease being used there. In fact, aren't the selectors lubricated from the inside via that splashing gear oil?
 
I assume they are talking about the ends of the selectors where the gear shift lever rides.
 
Moss probably also ships these springs for use in the plungers that lock the selectors in position.

You have adjusting screws on these to set the spring pressure.
Grease on these is probably goog because they wont get much oil lube.
 
Obsessions: I just took it all apart and dropped in grease in there. Set record time. About 45 minutes.
 
Back
Top