• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Tonight's Trivia - bearings

Share this page

JPSmit

JPSmit

Moderator
Staff member
Silver
Country flag
Offline
So, does anyone know what car bearing # 5-924 (VB) fits cause it sure in @#%%%&* doesn't fit a Midget.

While were on the topic, I cleaned out the seal (Rubber not paper) and not only was there a little O-ring in it but it almost seemed glued in - I had to carve it out. anyone had this experience?
 
JP, 5-924 is the kit number for MGB/MGC rear wheel hubs.
The Spridget P/N is 5-922, bearing, seal, gasket and "O" ring.
I've had to dig out many old "O" rings over the years. A dental pick works well.
Make sure you install the paper gasket when you reassemble.
Jeff
 
thanks - does this mean I should not have taken out the rubber seal the o-ring sat in?
 
J-P, are we talking about the rear seal / hub here?

If so, there's a flat paper gasket, and under it a rubber O-ring that gets crusty and needs to be cleaned out & replaced.

Behind the bearing, there is *also* a rubber axle seal, that is held in place by an internal metal circular spring. If that's what you mean, yes it needs to come out, and be replaced.

I did this last week, and have pix that might help if you run into problems.
 
Back
Top