• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

To hone or not to hone?

Share this page

Morris

Morris

Yoda
Offline
My cylinder bore is right at stanard size for my 1500. If I hone, could it push my cylinders past standard tolerances thus requiring an engine bore? How much does a hone typically take off?
 
Ask your machine shop. sometimes that can be done and honeing a must for new rings to seat. Kind of depends how much your cylinders are worn.
 
Check bore size down in the bore, bout half way down or more. This is where you will find an egg shaped bore. check perpendicular(did I spell that right?) to crank.
 
I didn't think you can really get an egg shaped bore with an inline motor. To the best of my knowledge, egg shaped bores are a "V" motor issue.
 
Nope. they will and in some cases they will wear at the bottom of the bore lateral to the crank too(caused by I believe crank flex)! the piston doesn't care about a V or not it only sees loading from the rod against the bore side away from the rotation.
 
Back
Top