• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

To dip or sandblast the AH frame

Share this page

I had my chassis dipped and E-coated. For the most part I was satisfied. However, ther was some stuff that ran out of some holes in the frame and left a little corrosion. If I were doing it over I would do as much of the welding and pannel replacement as possible before dipping so the the new stuff could be E-coated. Of course there will be some damaged places that will not be obvious until after dipping and must be dealt with.
 
Back
Top