Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
timmer2002
Freshman Member
Offline
I have to replace push rods on my 67 Austin healy sprite , I believe I will need to pull the head, to do it. I will be replacing lifters as well. Any tips would be greatly appreciated. thanks
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
timmers 67 Austin Healy enging work
- Thread starter timmer2002
- Start date
Share this page
Bob Branson
Member
Offline
No need to pull the head. Just remove the rocker arm and the two side plates on the block and you can pull out the pushrods and lifters. Have fun!