• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Timing - I feel like an idiot even asking

Share this page

G

Guest

Guest
Guest
Offline
Timing light on #1
What should it read when cranking?

I've spent so much time modifying electrical circuits to get a spark this week, that I've totally lost my mind

:totally embarrassed:
 
Uh, er, I run mine at BTDC, centrifugal advance, no vacuum.
If you are running ATDC, you will need a vacuum.
 
Alan -

May be some confusion here: BTDC means "Before Top Dead Center" - Advanced.

ATDC would then mean "After Top Dead Center" - Retarded.
 
I never used a timing light in the 49 years I've owned my TR3A. I get it running and take it out to warm it up. Then I rotate the distributor till I get the fastest running RPM. Then I reset the idle back to 800 RPM or so and drive it to see how it accelerates. If it's good, I advance it a bit with the vernier on the back side of the distributor and try it again. I keep doing this till it goes better and better. I also lug it in 4th gear to see if it's "pinking" or not. If it's not pinking, I advance it a bit more and try again. At some point when it accelerates like a bat, I lug it and find it's starting to "pink", I back off on the advance and check it again for "pinking". Then I know the timing is set for the next 5 years.
 
Which is the approcah I'll take when it actually starts - only in my case I can do it with a laptop.

So 10deg BTDC is about right. Bummer.
 
Back
Top