• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Tight Crankshaft [engine reassembly]

Share this page

Falkon said:
I had not torqued the down yet, and since I dont know exactly what u mean by having the block line bored I would have to say no on that one, but I do believe I had them recondition the rods. I have to check the reciept cause I don't know for sure.
Click to expand...

Line boring is a similar process to reconditioning rods. It is the process of making sure that the journals that hold the crank are truly round and properly in line with each other, and also within tolerance to fit the bearings and crank. This should include the or half moon seal (some call it an "eyebrow") at and above the rear main cap. It should be SOP for rebuilding an engine.
 
Yes the rods were checked and reconditioned. And I did have an ice cold cup of my special mix sweet tea in the process.
 
Falkon said:
Yes the rods were checked and reconditioned. And I did have an ice cold cup of my special mix sweet tea in the process.
Click to expand...

But not the block?
 
Back
Top