• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Thrusts, cam brgs, crank and cam timing

Share this page

Brosky

Brosky

Great Pumpkin
Offline
The cam bearings are in, the block was honed after boring and the final crank polishing before assembly. After another soapy bath the engine block was assembled and a few shots of the degree wheels and dial indicators. Then the block assembled just before I picked it up.
 
A thing of beauty!
 
2wrench said:
Cam bearings appear to be 360 degrees. How'd they
get em in there?
Click to expand...

Line bore the journals oversize, press the bearings into place, ream to size. Pricey but prudent.
 
D'ya think their degree wheel is BIG enough???
 
Back
Top