• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Thermal sensor

Share this page

R

rossco

Jedi Trainee
Country flag
Offline
Ready to replace sensor into orifice on side of radiator. Fitting is not turning freely, outer spring wants to spin while turning wrench. I've stopped fearing that will twist inner connection and break the fitting. How do I move ahead without damaging the part?
 
if you mean that the capillary tube is turning with the brass adaptor, then the only thing I can think of is soaking the end/fitting in a calcium/rust remover over here we have a product called CLR[calcium-lime-rust remover] which I think may work, failing that the other alternative would be to remove the gauge bracket so that it could turn as you install the fitting, good luck
Russ
 
Russ. I have that product . I'll do as you suggest. I do hate the idea of messing with the gauge but better than breaking the piece. Thank you. R
 
Back
Top