Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Not sure if this is a dumbass question or not but what was the reason for an "aluminumn" plug in the head? Was this in case the water? froze in the engine block, the plug would be forced up and relieve the pressure, similar to the frost plug in the block? The original plug in the TR3 head was replaced at a rebuild with another aluminumn plug only this one was threaded into the head.(been in there for years with no sign of corrosion.) If they do corrode ,as was mentioned before, would I not be further ahead with a "cast iron" NPT plug to avoid corrosion issues? On the other hand aren't there aluminum compatible antifreezes on the market that would make corrosion a non issue? Randall?
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR2/3/3A The Aluminum Plug in the Cylinder Head ?[Again]TR3
- Thread starter karls59tr
- Start date
Share this page
TR3driver
Great Pumpkin - R.I.P
Offline
Like most "freeze plug" holes, the hole in the head was actually used to help support the cores that form the coolant passages during the casting process. The cores are normally made from sand that is only lightly stuck together (so it can be broken up and removed once the cast iron is cool), so they need to be well supported in order to not break or shift during the casting process. Once the casting is finished, the hole is of no further use, so it gets "permanently" plugged.
https://en.wikipedia.org/wiki/Core_(manufacturing)
BTW, there is no "freeze plug" in the block on TRactor motors, because they are cast without the liners in place and thus there are plenty of places to support the cores. Go look
There are some other plugs of course, but they also have to do with casting or machining processes. There is no attempt to preserve the block during freezing.
You are quite right, the plug should not corrode, IF the antifreeze is always kept up to date. Antifreeze contains various compounds to protect the aluminum.
But, those anti-corrosion additives wear out over time, even if the engine is not driven at all. Most people don't bother changing the coolant when they haven't driven the car, which allows the corrosion to proceed. If you look inside the thermostat housing, you can get some idea of how bad the problem is. On my previous 56, it was literally paper thin in places and had been 'buttered' with some sort of adhesive to try to stop the leaks.
https://en.wikipedia.org/wiki/Core_(manufacturing)
BTW, there is no "freeze plug" in the block on TRactor motors, because they are cast without the liners in place and thus there are plenty of places to support the cores. Go look
You are quite right, the plug should not corrode, IF the antifreeze is always kept up to date. Antifreeze contains various compounds to protect the aluminum.
But, those anti-corrosion additives wear out over time, even if the engine is not driven at all. Most people don't bother changing the coolant when they haven't driven the car, which allows the corrosion to proceed. If you look inside the thermostat housing, you can get some idea of how bad the problem is. On my previous 56, it was literally paper thin in places and had been 'buttered' with some sort of adhesive to try to stop the leaks.