• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Terminal and Connector Help

Share this page

DNK

DNK

Great Pumpkin
Offline
I'm rewiring the ECU plugs in the Wedge and have gotten stumped on how to remove the terminals out of a Delphi 150.2 connector
View attachment 43856

Anybody have history with these?
 
Yes. I may have the tool still, and probably a bag of connectors.
Rectangular or round?

Been a LOT of years...some you flex the tab down (just visible lower left in your photo), usually have a small flat bar that slides in to release the catch.

Dave
 
[h=1]https://www.waytekwire.com/item/422/REMOVAL-TOOL-METRI-PACK-150-/?gclid=CKqnoJSK9s0CFVBhfgodkG0AzA[/h]
 
Have all those.
The pull to seat 150.2 is a real bugger.
I can't get the tang to release
 
You have to push to release. Then insert the tool while holding connector pin forward. The catch seats in a groove. IF I recall my days on General Misunderstandings. That's why they are called "pull to seat".
 
Back
Top